 | My cabinet has 2 shelves installed. I would like to put a lazy susan on both shelves. For the lower shelf, does the hardware install from the top of the product? The upper shelf will allow LS to be install from the top or bottom. - Asked about product RAS-6421-28-15-52 |
|  | This is a single Lazy Susan that is bottom mounted. There is a pole that is available, and it would need to be mounted to the top of the cabinet.
|
| | 0% of 0 people found this useful. Was this useful to you? Yes (0) | No (0) |
|
 | where do i measure fom so i get the right size - Asked about product RAS-6421-32-15-52 |
|  | Good Afternoon, First, determine your minimum cabinet width to ensure your installation will fit. Measure left to right within the face frame (also measure top to bottom and note the height). Subtract a few inches from each side to ensure your Lazy Susan can spin comfortably.
|
| | 0% of 0 people found this useful. Was this useful to you? Yes (0) | No (0) |
|
 | What is max weight that lazy Susan can support? Can it handle glass bowls or pots pans? - Asked about product RAS-6421-32-11-52 |
|  | The max weight capacity is 70lbs per shelf. Yes, it can handle pots and pans and glass; just don't put oil containers on the shelves, as it can cause cracking. Weight must be evenly distributed.
|
| | 0% of 0 people found this useful. Was this useful to you? Yes (0) | No (0) |
|
 | I have a kidney shaped lazy Susan under cabinet type and it measures 16" from center post to the outer edge. So would I order a 32" to replace my current one that has cracked shelves on it? - Asked about product RAS-6421-32-11-52 |
|  | In order to fit a 32"D Susan into the cabinet, you need to ensure you have enough space. You need to measure the radius. (The radius is the distance from the center of the circle to its edge.)
|
| | 0% of 0 people found this useful. Was this useful to you? Yes (0) | No (0) |
|
 | How is the diameter measured? - Asked about product RAS-6421-32-11-52 |
|  | The radius is the distance from the center of the circle to its edge. If the radius of the circle is 4 cm, then the diameter of the circle is 4 cm x 2, or 8 cm. If you know the circumference of the circle, divide it by π to get the diameter.
|
| | 0% of 0 people found this useful. Was this useful to you? Yes (0) | No (0) |
|
 | I measured that a 28 inch 270 degree lazy susan tray will fit in the cabinet, but I'm not sure it will fit through the front to get it in there. The four pre drilled factory cabinet holes in the shelf are set back from the front of the shelf a few inches. The radius of the 270 cut out at the front of the cabinet is 12 inches. I guess I will rotate the lazy susan inward on a diagonal using its cut out section. But should I be ordering a 24 inch lazy susan or 28? The smallest part of the cabinet from the center of the predrilled holes is 14.5 inches, so a 28 will fit IN the cabinet. Door is separate. - Asked about product RAS-6421-28-11-52 |
|  | Since all cabinets are made differently, Rev-a-Shelf recommends making a paper or cardboard cutout of the size and shape of the Lazy Susan shelf you are planning to use and placing it thru the door and in the cabinet to insure that it will rotate.
|
| | 0% of 0 people found this useful. Was this useful to you? Yes (0) | No (0) |
|